![]() For my masks I normally use a light grey as a middle ground between black/white. Of course if you have cold cast it or used coloured resin as show in the video you may want to skip to weathering your mask.įirst give the mask a coat of primer. Now you have your finished mask and you have removed any excess resin it’s time to paint it. When you are happy, follow this up with 280, then 400 grit for a smooth finish. ![]() Once all the spots have vanished give it another coat of spray to double check and if any spots remain sand them down. ![]() Any remaining primer showing after this will show up any low spots. For this stage I wet sand using 180 grit sandpaper this helps cut down on dust. If the first cast is going to be sanded, first prime it with some spray. I will suggest some alternative materials that can be used below Rather than do a write up on how to mould, I recommend the below video tutorial on how to make a brush on mould. If you are going straight from your finished clay sculpt to end mould, I suggest, even if it looks perfect to give your sculpt a final once over for mistakes. It may be possible to harden the clay and then rake or even sand it, but I haven’t tested this out. These come in various shapes as seen below.Īlternatively you can also heat the clay gently with a heat gun or hand torch and then go over the surface with a wire rake. To smooth out the clay I use spray lubricant such as WD40 in combination with fine wire rakes. This may be possible with other oil clay, but I haven’t had any luck doing this with Chavant.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |